TemperatureSensor accessory (Spa) indicating the ambient temperature of the Spa (last known temperature if pool isn't running).TemperatureSensor accessory (Pool) indicating the ambient temperature of the pool (last known temperature if pool isn't running).TemperatureSensor accessory (Air) indicating the ambient temperature where thee screenlogic hardware is located.} Implemented HomeKit Accessory Types Air Temperature 'hidden_circuits': 'Fountains,Floor Cleaner,Aux 6 ' Default is false.ĭisabledLightColors an array of strings with the names of light mode/colors you want to disable. Default is 60 seconds.ĬreateLightColorSwitches will create a 'Pool Lights' accessory that contains switches for turing on light modes/colors.

'statusPollingSeconds' time in seconds to poll for pool statu. 'hideSpaThermostat' hides the spa thermostat (aka, spa heater) if you don't want to allow changes via HomeKit. 'hidePoolThermostat' hides the pool thermostat (aka, pool heater) if you don't want to allow changes via HomeKit. 'hideSpaTemperatureSensor' hides the spa temperature sensor, which is redundant if you are showing spa thermostat. 'hidePoolTemperatureSensor' hides the pool temperature sensor, which is redundant if you are showing pool thermostat. 'hideAirTemperatureSensor' hides the air temperature sensor. Set this for circuits you don't want showing up as switches. I'm not sure if my ISP has changed my public IP between the time we set this up until today, but even if they did, I would think resetting the protocol adapter would cause it to phone home again and update the IP address.Īnyone have any ideas? Considering I was able to connect on day 1, I don't think this is a firewall or router config issue but am open to suggestions.'hidden_circuits' comma-separated list of circuit names to hide. I realize the protocol adapter phones home to Pentair, and reports the public IP of my router, and then uses this to allow remote connection. I have a static IP address assigned to it in my router as well. I've already tried unplugging and replugging the power to the protocol adapter, and it hasn't worked. Prior to hanging on 'Requesting gateway connection', I can see other messages flashing, but it's too fast to be able to read them. I've tried several times, and it hangs on 'Requesting gateway connection ' for a minute or so, then displays the error. but when I tried, I get 'ERROR: Cannot connect' so I thought, -I can answer that Just log into ScreenLogic.

my wife made a comment 'I'd really like to swim today, I wonder what the water temp is?'. When we initially installed the ScreenLogic setup, I used my phone to connect to it remotely (ie: I shut my phone's WiFi off, and connected over the Since then, I've been connecting locally (while on my home's WiFi) and all has been fine.

Pentair screenlogic remote connection